Typical Installations; Plan The Installation - Broan QTXE110H Mode D'emploi

TYPICAL INSTALLATIONS

BH0001A
Housing mounted to
I-joists.
Housing mounted to joists.
05A
Housing mounted anywhere
between trusses
using hanger bars.

PLAN THE INSTALLATION

1. Choose the
installation
location.
The location of
your humidity
sensing fan is
very important.
Use the following
guidelines for
best operation:
002A
Housing mounted
anywhere between I-joists
using hanger bars.
Housing mounted
anywhere between joists
using hanger bars.
BH0006A
Housing mounted anywhere
between trusses
using hanger bars.
INSULATION
(Can be placed
around and over
fan housing.)
FAN
HOUSING
6-IN.
ROUND
*
DUCT
*
Purchase 6-IN. ROUND
*
separately ELBOW(S)
• Locate unit above (GFCI protected circuit required) or
within 5 feet of shower head.
• Locate unit away from heating or cooling sources which
can affect humidity levels.
• Do not locate near window. Unit may respond to the
outdoor humidity level.
• Unit must be installed in ceiling to properly sense
moisture.
• Locate unit only on fl at ceilings up to 12 feet high for
proper sensing.
• The fan will operate most effi ciently when located where
the shortest possible duct run and minimum number of
elbows will be needed.
2. Plan the wiring.
• Plan to supply the unit with proper line voltage and
appropriate power cable. Power cable should be
routed to the switch box fi rst and then to the unit (See
"CONNECT WIRING" on page 3).
• Do not operate this unit with a speed control. Damage
to the sensor unit will result.
INSTALL HOUSING
& DUCT
1a. Mount
housing
to joist
or I-joist.
Use pliers to
bend housing
T A B S
to 90°. Hold
h o u s i n g i n
place so that
t h e h o u s i n g
tabs contact
t h e b o t t o m
o f t h e j o i s t .
The housing
mounts with
four screws or
nails. Screw or
ROOF
nail housing to
CAP *
joist through
lowest holes in
each mounting
flange, then
t h r o u g h
highest holes.
NOTE: Mounting to I-JOIST (shown) requires use of
SPACERS (included) between the highest hole of each
mounting fl ange and the I-joist.
WALL
CAP *
MODEL QTXE110H
TABS
o u t
BD0001
SPACER
(use for mounting to I-Joist)
OR
Page 2
I-JOIST