Service Parts - NuTone QTREN Serie Mode D'emploi

CONNECT WIRING
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use proper
UL approved connector to secure house wiring to wiring plate.
Connect wires as shown in wiring diagrams.

SERVICE PARTS

Key No. Part No.
1 97016466 Housing
2 97016449 Duct Connector - 4"
3 98010102 Wiring Plate
4 99170245 Screw, no. 8-18 x .375"
5 97018010 Wire Panel/Harness Assembly
6 10941260 Blower Assembly (QTREN090C)
10941261 Blower Assembly (QTREN110C)
7 97016772 Grille Assembly
(includes key no. 8)
8 99140199 Grille Spring (2 req'd)
9 99111293 Spacer (2 supplied)
10 97016909 Hanger Bar Kit
Order service parts by "Part No." - not by "Key No."
SERVICE NOTE
To remove Blower Assembly:
Unplug motor (6).
Remove screw (4) from motor plate flange.
Find the single TAB on the motor plate (located next to the
receptacle).
Push up near motor plate tab while pushing out on side of housing.
Or insert a straight-blade screwdriver into slot in housing (next to
tab) and twist screwdriver.
Description
MODELS QTREN090C • QTREN110C
INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach grille
to housing.
Squeeze grille
springs and insert
them into slots on
each side of
housing.
7. Push grille
against
ceiling.
10
2
BO0001
1
9
9
3
10
5
6
TAB
8
4
7
99043659D
Page 4
4