PIAA Powersports 510 Instructions D'installation page 3

Phares
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

LAMP
INSTALLATION
• The installation area must be clean and level with enough working space
to complete the job without distractions.
• The PIAA lamps are to be mounted hanging down. For an upright mount
install lenses with PIAA logo right side up. To flip the lens follow the lamp
service diagram.
• For the lamp system to function properly the supplied PIAA harness
must be used.
• When mounting the lamps mount them in such a place that they are free
of obstructions.
• Do not modify the lamp system in any way or it will void the warranty.
• Do not mount the lamps in a place that will obstruct an existing
vehicle function.
• Do not mount them so low to the ground that they scrape.
• When a lamp mounting location has been decided a 10mm hole will be needed
to mount the lamp with the supplied mounting hardware. If a hole is not
available, one will have to be drilled.
• When lamp is mounted make sure to leave at least 1/8 inch clearance around
the lamp to avoid heat damage to any vehicle part.
3.
3. 3.

Publicité

Table des Matières
loading

Produits Connexes pour PIAA Powersports 510

Ce manuel est également adapté pour:

P212169Lp530Lp570 dk575bwg

Table des Matières