Failure To Operate - Carobels SculpBy Manuel D'utilisation

Important Safety Instructions
5. Maintenance instructions
Cleaning your SculpBy hair straightener:
a) Unplug the SculpBy styler from the mains power supply.
b) Always allow the SculpBy styler to cool before attempting to clean it.
c) Never immerse the appliance in water.
ES
d) Wipe the outside of the SculpBy styler with a damp cloth. Do not use sharp or abrasive
detergents or corrosive products.
6. Operation
EN
a) Plug the appliance into the outlet. Move the button ON/OFF switch to the ON position. The
LED light will switch on, indicating that the tool is in use.
b) The temperature of plates rises quickly, after 50 to 60 seconds the plates achieve the selec-
ted temperature for use. In the CX1 PLUS hair straightener select the desired temperature
FR
using the temperature control button. Temperature: 120 ° C (minimum) - 220° C (maximum).
c) The LED light will remain indicating the temperature on while tool is in use.
d) To switch off the tool, move the button ON/OFF switch to the OFF position, the LED light
turns off.
e) Wait until the plates reach the setting temperature to carry out styling and use it in a correct
way by holding it by the handle when styling.
f) In order to use it, please put DRY hair between the two plates, press the handle closing the
hair straightener, and then slide it down towards the end of the hair.
g) Do not use the device for any other purpose than its intended use.
20
7. The SculpBy CX1 PLUS hair straightener has the following safety features
Incorporate Auto Sleep Mode: if the hair straightener is ON and it is not in use for more than
60 minutes, the integrated intelligent microprocessor allows its automatic off, thus increasing
the safety of its use.

8. FAILURE TO OPERATE

a) In the unlikely event that your SculpBy product does not operate correctly, check that the
SculpBy product and mains power supply are switched on, and that power is available.
b) If in doubt or for further advice please contact the customer service.
9. Recycling and disposal
Your SculpBy electrical product is classified as 'electrical or electronic equipment' and must not
be disposed of with other household or commercial waste at the end of its working life. When
you have no further use for your SculpBy product, please dispose of it according you your local
authority's recycling procedure. Your SculpBy electrical product should be disposed of in accor-
dance with the WEEE directive (Waste Electrical and Electronic Equipment 2002l96/EC) which
ensures that products are recycled using the best available methods and practices to minimise
any potential damage to the environment. For more information, contact your local authority or
the retailer from whom you purchased this product.