Work WG779 Mode D'emploi page 20

Tondeuse à gazon sans fil 2 en 1
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Mower runs but
cutting performance is
unsatisfactory, or does
not cut entire lawn.
4. Mower is too hard to
push.
5. Mower is abnormally
noisy and vibrates.
6. Battery charger LED's
not on.
7. Battery charger LED
does not flip to green.
8. Mower not picking up
clippings with the Grass
Collection Bag.
20
9. When mulching there
are clippings visible.
10. Low or diminished
run-time after many uses.
11. The battery charger
LED flashes red and the
battery can't be charged.
For Battery tools
The ambient temperature range for the use and storage of tool and battery is 0°C-45°C
(32°F-113°F).
The recommended ambient temperature range for the charging system during charging is
0°C-40°C (32°F-104°F).
2 in 1 Cordless Lawn Mower
A. Has battery been fully charged? Plug in charger and wait for
green light to come on.
B. Release bail handle to turn mower off. Remove safety key. Turn
mower over and check: Blade for sharpness - Keep blade sharp.
Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass
condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass. Check each
wheel for free rotation.
A. Release bail handle to turn mower off. Remove safety key. Turn
mower on side and check blade to ensure it has not been bent
or damaged. If blade is damaged, replace with a replacement
blade. If the underside of the deck is damaged return mower to an
Authorized service center.
B. If there is no visible damage to the blade and the mower still
vibrates: Release bail handle to turn mower off, remove safety
key and remove blade. Rotate blade 180 degrees and retighten.
If mower still vibrates, return the mower to an authorized service
center.
A. Check plug connection.
B. Replace charger.
A. Battery needs to be diagnosed. Take to authorized service
center.
A. Remove mulch plate when bagging.
B. Chute clogged. Release bail handle to turn mower off. Remove
safety key. Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten
length of the cut.
D. Bag full. Empty bag more often.
A. Too much cut grass. Raise cutting height of wheels to shorten
length of the cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
A. Return to Authorized Service location - may need new battery.
A. The battery overheats after continuous use. Remove battery
from the charger and allow it to cool to 42
C or less.
o
EN

Publicité

Table des Matières
loading

Produits Connexes pour Work WG779

Ce manuel est également adapté pour:

Wg779.x

Table des Matières