Gardebruk 106537 Mode D'emploi page 38

38
Fault
Motor does not run
Chain does not move
Poor cutting performance
Saw works only with
difficulty /Chain jumps off
sword
Chain becomes hot
Strong odour formation and
increased flying
Carbon pins are wear and spare parts and may only be installed by authorised specialist
personnel.
Carbon pins are wear and spare parts and may only be installed by authorised specialist
personnel Do not use tools where the switch cannot be switched on/off For all other
malfunctions, please contact authorised service centre, our central service departmen
or your dealer.
Running out of carbon brush
Check that the chain is fitted correct Check the chain tension
worn charcoal pencil
www.DeubaXXL.de
Cause
No electricity
Chain brake
chain brake
Blunt chain
Chain tension
Chain tension
Chain lubrication
Remedy
Chek socket,cable and plug.
Damaged cable: Have repaired by
Customer Service. It is prohibited to
patch the cable with insulating tape.
Damaged sw itches have to be
replaced by a Customer Service
workshop.
See action switches have to be
replaced by a customer Service
workshop.
Change the carbon brush, ask a
customer service workshop.
Check the chain brake, release if
necessary
Sharpen the chain
Chain wrongly fitted
Check the chain tension
Check oil level/Chain lubrication
Stop operation of the machine
Renewal of the charcoal pencils by
our customer service department