Getting Started; Installation; Connect To Your Tv; Using With An External Antenna - Philips SDV4235/10 Manuel D'utilisation

3 Getting Started

STOP
Before you start: For this antenna
to work properly, you must access
the menu on the television you are connecting
this antenna to (consult your television owner's
manual) then set it to receive the signal from an
ANTENNA instead of CABLE or SATELLITE.

3.1 Installation

Determining Signal Strength
Before Installation determine the best location
for optimum reception. It is important for the
antenna to have an unobstructed path to the
transmitter. For best results, the antenna should
be facing the transmitter location.
E Tip
Where possible, choose a location near a
window which will give the antenna a clear view
of the transmitter.
E Tip
Do not place the antenna on a metal surface.

3.2 Connect to your TV

Connect the signal output on the antenna
1
to the TV.
1
Connect the power supply from the antenna
2
to a 230-240V outlet.
-or-
Connect 12V DC adaptor plug (not
included) to antenna and plug in.
4
3.3 Using with an external antenna or
other video source
Your antenna is equipped with a mode selector
switch (A/B switch) that allows you to have
more than one video source.
To use your SDV4235/10 as an internal
amplifi ed TV antenna simply slide the switch
to INT position. To use an external antenna
or other video source simply slide the switch
to EXT position.
2
If you are using the antenna with the switch
in the EXT position, make sure that your
external antenna or other video source is
connected to the EXT ANT input located
on the back of the antenna.
3
1
TV
ANT.
2
3