Operation - STERWINS 360 ESC Mode D'emploi

OPERATION

Always keep to instructions on safety and current rules and regulations.
Apply only a gentle pressure to the machine.
Hint and suggestions
How to use your scarifier
• By scarifying you remove the hardened surface, grass felt and flat-growing
weeds and the crusted over garssroots are loosened up. The lawn will start to
breath again and assimilate the nourishing substances, oxygen and water. This
also prevents the establishing of becteria in the lawn felt during the wintertime.
• Cut the grass to a height of about 40mm before scarifying. The lawn must be
dry when using the maching. The best time for an scarifying is any time during
the vegetative season, from end April through to September. Scarify it at least
once a year. We recommed using a fertilizer straight after airing if you want a
green carpet.
How to use your raker
• By raking you remove the dead matter, moss and weed which disfigures a lawn.
The build up of dead grass provides a mat of absorbent fibres which prevents
water getting through to the ground.
• Do not force your rake through grass that is longer than 75mm. The lawn must
be dry when using the machine. It's recommend that your raker is used at
the beginning and the end of each grass cutting season to give your lawn a
thorough raking. Your raker should also be used after each mowing to remove
any grass cutting that may be left by your mower.
POWER CONNECTION(FIG. 7)
fix the cord by the cord clip and cord grasper
Note: The packaging material is made of recycle materials. Dispose of packaging
materials in accordance with regulations.
CAUTION!
Do not switch on the unit until it has been completely assembled. Before
switching on the unit, always check the connection cable for signs of
damage; only on undamaged connection cable may be used.
Note: Damaged connection cables are highly dangerous!
The mains voltage (230V~240V) indicated on the rating plate must correspond with
the mains power supply. Mains connection fuse: min.10A.
1) Insert the mains plug of the unit connection cable into the combined switch/plug.
(As fig 5 show)
2) Secure with the cable grip. The loop of the mains cable must be adequately long
so that the cable grip can slide from one side to the other.
Switching ON/OFF (FIG. 8)
Switch on: press the button on the combined switch/plug. Hold down the on
button and pull the switch bar
1
towards the handle and hold in position
2
EN - 15