Resetting The Device To Factory Settings; Technical Data; Useful Information About The Baby Monitor; Storage And Maintenance - Sanitas SBY 98 Notice D'utilisation

Default
Resets all settings to the factory settings.
If no button is pressed for five seconds, or the On/Off button is pressed, the
settings menu disappears.

Resetting the device to factory settings

To reset the device to factory settings, use a sharp object to press the reset
button on the monitor and on the camera.
8.

Technical data

• 16 channels
• Frequency 2.4 - 2.483 GHz
• Digital receiver
• 2.4" TFT display
• Infrared technology
• ECO mode
• Dimensions: camera Ø 82 mm x 75 mm / base: Ø 90 mm /
monitor: 130 x 76 x 31 mm / stand: 105 x 64 x 45 mm
• Weight: camera 93 g; monitor 117 g; battery 80 g
• 200 m range with a clear view
Operation
Battery life
(dependent on battery state,
ambient temperature, method
and frequency of charging, etc.)
Camera and monitor mains part plug:
input: 100-240 V ~50/60 Hz, 200 mA;
output: 5 V 1 A
Monitor: Lithium ion battery 3.7 V; 900 mAh
Monitor: approx. 9 hours in ECO mode
approx. 5 hours in LCD mode
9.

Useful information about the baby monitor

• If you operate the monitor with the battery, this minimises electrosmog
from electrical and magnetic alternating fields.
• You can increase the range of the baby monitor by positioning the camera
as high up as possible near a door or window and ensuring that the
battery is not too weak.
• Other radio waves may interfere with the transmission of the baby monitor.
Therefore, do not position the baby monitor near devices such as micro-
waves, WLAN, etc.
• The following other factors can interfere with the baby monitor's trans-
mission or shorten its range: furniture, walls, houses, trees, environmental
factors (such as fog, rain).

10. Storage and maintenance

The service life of the devices depends on careful use:

Important:

• Remove the battery if the device is not in use for an extended period.
• You will get the maximum capacity from your battery if you run down the
battery at least once every six months. To do this, disconnect the device
from the mains and run the battery down through normal use. Then fully
charge the battery up again.
• The maximum battery capacity can only be reached after it has been
charged several times and is dependent on many factors (battery state,
ambient temperature, means and frequency of charging, etc.).
• Protect the devices from knocks, damp, dust, chemicals, drastic changes
in temperature, electromagnetic fields and nearby sources of heat (ovens,
18