Publicité
Les langues disponibles
Les langues disponibles
VIII. Paring the eXo with a computer that does not have a
Bluetooth® Transmitter (PC Only):
1. Insert the included CD to your system.
Click on the Setup icon.
2. Select your language.
3. Accept terms of license agreement.
4. After installation,
connect the Bluetooth® USB dongle to your system.
5. Click on the Launch Blue Manager Suite Icon located on your desktop (shown below).
The Blue Manager application will launch.
6. Under Bluetooth® Neighborhood, select Peripheral Devices and
double click the indicated area to perform device discovery.
7. A search for Bluetooth® devices will start.
In order to become discoverable, the eXo
must be in pairing mode. See section entitled
V. Paring for instructions on how enter the
eXo in paring mode.
8. When the Bluetooth® is enabled, the window below
will display "Pointing in Range" and
"Connectable Mode."
Click OK to proceed.
The Bluetooth® mouse driver will be installed.
9. Once the device is properly installed,
the Bluetooth® icon on the system tray Will turn from Blue to Green.
IX. LED Indicators:
Status
⑤ RED LED
Stanby mode
OFF
OFF
Power On
OFF
Blinks Once
When Pairing
Blinks Alternate RED & GREEN Until Paring is Complete
In-use
ON When Device is Being Used
OFF
Text Size
Blinks once for 400dpi
TEXT Size
OFF
Blinks once for 800dpi
Low Battery
Blinks
OFF
Very Low Batt.
Blinks RED and Green 10 times simultaneously then Power off
X. Troubleshooting
Trouble
Ensure the device is powered
on. By checking that the Green
eXo Does not Work
LED is blinking.
Battery power is weak.
eXo Is not properly paired
eXo isn't Working After
with the computer.
Rebooting the PC
The eXo is not in pairing mode.
(Check LED indicator status)
Can't Pair the eXo to the PC
Laser Pointer Does Not Work
Battery on the unit is dead.
Charging cable is not properly
connected.
eXo Does Not Charge
<Green>
⑥ GREEN LED
Status
② LED
Charging
RED LED
is On
Green LED
Full
is On
Charging
Laser
RED LED
Pointer
is On
Indicator
Reason
Troubleshooting
Switch the power switch to On.
Charge the battery.
Turn OFF the eXo and turn it
back ON this should allow the
computer to rediscover
the device.
Get the eXo into pairing mode
by depressing the Page Up
button ① and Page Down
Button ③ at the same time for
5 seconds. Reinitiate the paring
process on the PC.
Charge the battery.
Check if the plug on the
charging cable is properly
inserted into the eXo and check
the LED status.
Publicité
