JVC KD-ADV7380 Manuel D'instructions page 57

Symptom
• Bluetooth device does not detect the unit.
• The unit does not detect the Bluetooth device. • Check the Bluetooth setting of the device.
• The unit does not make pairing with the
Bluetooth device.
• Echo or noise occurs.
• Phone sound quality is poor.
• The sound is interrupted or skipped during
playback of a Bluetooth audio device.
• The connected audio device cannot be
controlled.
* For Bluetooth operations, refer also to the instructions supplied with the Bluetooth Adapter.
Remedy/Cause
The unit can be connected with one Bluetooth cellular
phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
from another device. Disconnect currently connected
device and search again.
• Search from the Bluetooth device. After the device
detects the unit, select "OPEN" on the unit to connect
the device. (See page 29.)
• Enter the same PIN code for both the unit and target
device.
• Select the device name from "SPECIAL," then try to
connect again. (See page 30.)
Adjust the microphone unit position.
• Reduce the distance between the unit and the
Bluetooth audio device.
• Move the car to a place where you can get a better
signal reception.
• Reduce the distance between the unit and the
Bluetooth audio device.
• Disconnect the device connected for "BT-PHONE."
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the
device again.
Check whether the connected audio device supports
AVRCP (Audio Video Remote Control Profile).
Continued on the next page
REFERENCES 57