Before You Start; Network Setup - Audizio TURIN Guide De Démarrage Rapide

BEFORE YOU START

Please ensure the following is ready:
You have a broadband internet connection. A wireless broadband router is connected to the internet successfully. The radio
supports Wireless B, G and N connection (Wireless N router can also be used with the setting on B or G). You know the Wired
Equivalent Privacy (WEP) or Wi-Fi Protected Access (WPA) data encryption code/password. You need to key in the correct
code when the radio is connected to the wireless router for network connection. If you do not know the code/password,
please contact the person/technician who set up the router/network for you. The radio can work via Wireless network
connection (Wi-Fi connection) and wired connection (ethernet RJ45).

NETWORK SETUP

Internet connection can be setup via Wired LAN or Wireless LAN (WiFi). Your Radio requires a broadband Internet connection
through wired Ethernet or WiFi. The easiest way is use a CAT 5 or CAT 6 cable to connect through wired Ethernet to a Wifi
router, which connects to an Adsl modem or a cable modem provided by your ISP.
WPS connection is available if your router has a WPS button. To configure the network via remote app, see [under Wi-Fi
Network > Add AP (SmartConfig)] for more details.
Wired LAN (Ethernet)
For Wired Ethernet connection to a router with DHCP enabled, the network configuration for Internet connection is
automatically done and the Radio can be used for Internet radio and UPnP sharing without user interaction. When the
network is connected, the Ethernet icon
Wireless LAN (Wi-Fi)
•
If this is first time use, the Configure Network wizard will be displayed. Choose Yes to start configuring network.
Press the [◄ ] button to highlight Yes and press [OK] to confirm.
•
Select Add/Remove AP from the list, use the [▲/▼] button to scroll and press [OK] to confirm, then choose Add AP
(Scan).
•
It will start scanning the Wi-Fi networks available. Scroll to your network and press [OK] to confirm. If your wifi
network has a password protected, it will ask you to enter the passphrase/password.
Note: The password is case sensitive. Please consult with the one who setup your network if you don't know the password.
•
When the Wi-Fi connection is successful, the Association Complete will be shown briefly. The wifi signal bar will
appear on the top left corner of the display.
BT PLAYBACK
Before transmission between your BT device and the radio is possible, both devices must be coupled. This process is called
"pairing". The radio is served as a receiver, to receive music stream to play on the radio.
If you have already coupled to a BT device before, this connection will be restored automatically when both devices are in
range and BT operation has been selected on the radio. "Pairing" does not have to be repeated. This function
may need to be activated in your BT device, however.
•
Push the [ ] button to display the selection menu for the different operating modes.
•
Use the [▲/▼] button to select the operating mode BT and press [OK].
•
Switch your BT device to which you want to connect the radio on and activate the pairing mode here. The device
scans for BT devices in the reception range.
•
When the radio is found, your BT device shows its name Audizio Turin-XXXX (the XXXX is an identification code for
your radio unit).
•
Select the radio at your BT device.
•
Start playback on your BT device.
•
Playback now takes place using the radio.
QUICK START GUIDE
will appear on the top left corner.