Goldline Controls Sense And Dispense Guide De L'utilisateur page 21

Configuring the AquaRite Pro
After the Sense and Dispense™ is mounted, plumbed and wired, the AquaRite Pro must be
configured using the Chemistry Config. Wizard and pH Calibration Wizard. These wizards are
found in the Settings Menu of the AquaRite Pro.
Chemistry Config Wizard
The Chemistry Config Wizard will prompt the user for information and automatically configure
the AquaRite Pro to use the Sense and Dispense™ sensing kit. The procedure to perform the
Wizard is shown below. Detailed information about specific screens relating to the configura-
tion can be found on the following pages. To enter the Chemistry Config Wizard follow the
steps below:
1. Press the button.
2. Press ">" repeatedly until "Chemistry Config. Wizard" is displayed.
4. Push "+" to start Wizard.
5. Advance through the Wizard using "<" and ">" buttons. Use "+" and "-" buttons to answer
questions when prompted.
6. Continue until finished.
pH Reduction Control
Select the desired option related to pH control.
Disabled pH control is turned off. Select this mode if no pH dispenser will be connected
to the AquaRite Pro.
Auto Sensing
Use this mode when an automatic pH reducer will be used. The AquaRite Pro
will dispense pH reducer (acid) when necessary to prevent the pH level from
rising.
Forced On
pH reducer is added for 15 minutes regardless of pH level and then automati-
cally goes to Auto Sensing mode. This mode is helpful when setting up and
testing the automatic dispenser.
Chlorine Feed
Select the desired option related to chlorine generation.
ORP Auto
The AquaRite Pro refers to the ORP level in the pool and automatically adjusts
Sensing chlorine output to maintain a desired level.
Timed (%) The chlorine output is based on the manual setting only. ORP level is not used
to control the chlorinator output.
Maintain pH Level
The Wizard prompts you to enter the desired pH level (7.5 default). The AquaRite Pro will
dispense pH reducer when necessary to maintain this level. The adjustable range is from 7 to
8 in 0.1 increments. Enter the desired pH level.
pH Alarms
The AquaRite Pro will automatically set a high and low alarm for the pH level. The high alarm
point is 8.1 and the low alarm point is 6.9. If the pH level meets or exceeds these points, a
"Check System" message will display locally and on all remote displays.
7