Filling During Operation; Tips For Use; Cleaning And Care - OK. OMX 103 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
EN

FILLING DURING OPERATION

8
Turn the filling cap anti-clockwise and remove it.
9
Fill with ingredients.
10 Re-insert the filling cap into the lid opening section and turn it clockwise.
Caution: Never use this product to mix with hot oil or fat.
11 Turn the control knob to 0 and remove the blender jar from the motor block.
12 Open the lid and pour out the content.

TIPS FOR USE

• To achieve the best results for pureeing solid ingredients, only insert these into the blender in small
portions rather than filling a large amount at once.
• If you are working with solid ingredients, cut these into small pieces (2-3 cm).
• Start with a small amount of liquid when blending liquid ingredients. Then gradually add more liquid
through the lid opening section.
• You can stabilise the product correctly if you place your hand on top of the locked blender.
• It may be useful to use the pulse mode when blending any solid or very thick food products, as this
will prevent the cutting blade from becoming clogged.

CLEANING AND CARE

• Warning! Never immerse any electrical parts of the product in water or in other liquids during
cleaning. Never place it under running water.
• When cleaning, never use petrol or solvents, and do not use any abrasive cleaners or cleaning aids.
• Always clean the jar after each operation, first fill the jar half with warm water and operate at the pulse
setting for several times.
13 Set the switch to position "0", unplug the power cable from the wall socket.
14 Clean the blender with a long-handled cleaning brush so that you do not injure yourself on the
cutting blade. Warning! The cutting blade is very sharp.
15 Clean the lid and blender jar under hot running water with a damp sponge and mild dishwashing
detergent. Dry all of the pieces completely before using again.
Note: Detachable parts are dishwasher safe.
16 Clean the product's exterior surfaces with a slightly damp cloth and then dry them thoroughly.
Make sure that no water enters the product interior (for example, through the switch).
SPECIFICATION
Rated voltage
Rated power input
Continuous Operation time
Protection class
DISPOSAL
The crossed-out wheeled bin logo requires the separate collection of waste electric and
electronic equipment (WEEE). Electric and electronic equipment may contain dangerous and
hazardous substances. Do not dispose of this appliance as unsorted municipal waste. Return it
to a designated collection point for the recycling of WEEE. By doing so, you will help to conserve
resources and protect the environment. Contact your retailer or local authorities for more
information.
IM_OMX103_140919_V05_HR.indb 14
14
: 220–240 V~, 50/60 Hz
: 400 W
: 1 minute
: II
19/9/14 8:55 AM

Publicité

Table des Matières
loading

Table des Matières