Fiskars Fuse Creativity System Guide De Démarrage page 8

Die-cut + Letterpress
Follow these simple steps to die-cut and letterpress in one pass through the Fuse Creativity System
Choose a Die and
Letterpress Plate
Choose a letterpress plate and
place it in the coordinating
cutting die.
8
Place in Cover
Place orange cover
underneath cutting die.
Built-in pins raise the
letterpress plate, allowing
it to be inked.
Tip: When pushing the die
into the cover, be sure to
push it down past the tabs
inside the cover.
Ink the Plate
Color in the raised letterpress
plate design using standard
fabric-topped ink pads
or markers.
.
®
Preparing
Lift the cutting die with inked
letterpress plate out of the
orange cover. Without the
cover, the letterpress plate will
nest back into the die.
Place die with letterpress plate
on the machine's large deck.
Caution: Be sure to remove
the cover before putting the die
through the machine rollers.
Failure to remove lid will
damage die.