Mounting The Sensor; Operation - HAMPTON BAY CH-7903-02 Guide D'utilisation Et D'entretien

Installation (continued)
6
Mounting the push button
Use either screws (BB) or double-sided tape (CC) to
mount the push button (C).
□
To mount with screws (BB), remove the back
of the push button (C) by pushing in the tab
on the bottom with a small screwdriver. Place
the push button (C) back on the door jamb
and mark the two screw holes. Attach with
screws (BB) and snap on the front of the push
button (C).
□
When attaching the push button (C) with
double-sided tape (CC), remove the paper from
both sides of the double-sided tape (CC) and
apply to a clean surface.
7

Mounting the sensor

Attach the sensor (B) mounting bracket to a sturdy
surface using the screws (BB). Make sure the
sensor (B) has an unobstructed view.
□
Place the sensor (B) mounting bracket
in the desired location and mark the two
screw holes. Attach the sensor (B) with the
screws (BB).
□
If the motion sensor (B) was removed from the
mounting bracket, use a Phillips screwdriver
(not included) to loosen the clamp screw on
the mounting bracket. Insert the swivel ball
on the motion sensor (B) into the mounting
bracket until it snaps into place. Aim the
motion sensor (B) toward the area to be
monitored and tighten the clamp screw.

Operation

1
Adjusting the doorbell volume
The doorbell (A) has an adjustable volume control
located on the side. Rotate the thumbwheel up or
down to adjust the volume.
NOTE: Attach mounting bracket vertically when attaching
to a curved surface.
IMPORTANT: The sensor must be rotated so the controls are facing
down.
6
BB
BB
B
A