Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
PROBLEM
Trimmer runs slowly
Unit will not start
Battery will not charge
14
POSSIBLE CAUSE
Check that the spool housing can
rotate freely
Check that the cutting line does not
protrude more than approximately
5-3/8 inches (136mm)
from the spool.
Battery not installed properly
Battery not charged
Battery not inserted into charger
Charger not plugged in
Surrounding air temperature too
hot or too cold
POSSIBLE SOLUTION
Carefully clean it if necessary
If it does, cut it off so that it
just reaches the line trimming
blade.
Check battery installation
Check battery charging re-
quirements
Insert battery into charger
until red LED appears
Plug charger into a working
outlet.
Check current at receptacle
by plugging in a lamp or other
appliance.
Check to see if receptacle is
connected to a light switch
which turns power off when
you turn out the lights.
Move charger and tool to a
surrounding air temperature of
above 40 degree F (4.5°C) or
below 105 degree F (+40.5°C).
Publicité
Table des Matières
