URBANGLIDE RIDE 85XL Mode D'emploi page 6

1
Pull out the spring,
you will find the
connecting wire.
Please check that the holes on
the head of the scooter and on
the support post are in the same
place before screwing and
fixing.
2
Handlebar mounting
Take the handlebar out of
the scooter and you will find
two connecting cables which
you must align according to
the markings on the joints.
Then insert the handlebar
on top of them.
6
1
Please ensure that all wires inside
the head do not interfere before
inserting the front support post
into the scooter head. Otherwise
insertion may cut the wires.
After following the 4 previous
installation steps, your handlebars
should look like the picture.