Hardware Contents - HDX HD1848-5LHCCPS Guide D'utilisation Et D'entretien

Step 5: Casters Assembly
Lay unit on its side. Use care to not scratch the unit. If necessary,
lay the unit on a floor mat or flattened cardboard sheets. If casters are
required, un-screw feet levelers from bottom poles, slide a plastic
bumper up the bottom of post about 4 in - 6 in, smooth side facing up.
Screw in two locking casters (d) on one side of the unit and two
non-locking casters (d) on the other side of the unit.

HARDWARE CONTENTS

AA
Washer
Qty. 2
To prevent the unit from tipping over, secure it to a
wall in the following manner: Drill a hole in the wall
using a 1/4 in. drill bit (not included). Insert the
plastic anchor (BB) into the hole. Insert the screw
(CC) through the washer (AA) then through the back
of the top shelf wire and into the plastic anchor (BB)
as shown. Be sure unit is secure and doesn't
wobble or tip over.
BB
Plastic Anchor
Qty. 2
caster (2 - locking ; 2 - non locking )
CC
Screw
Qty. 2
AA
CC
BB