Switching On And Off; Modes - HUBER INSTRUMENTE HM30 Mode D'emploi

TEMP2
Pin Signal
1 Pt 100 power supply +
2 Pt 100 measuring input +
3 Earth
4 Pt 100 measuring input -
5 Pt 100 power supply -
3.4

Switching on and off

Switching on
Switching off
In the case of a temperature change the
instrument requires at least 30 minutes to
adapt to the new ambient temperature
(instrument OFF).
3.5

Modes

The following operating modes and functions
according to the table below can be selected
bypressing
successively.
On switching on, the instrument is always in
the last selected operating mode.
or automatic cut-out 1,
10, 30 or 60 min. after
the last keystroke.
respectively
Legend to the table of the next page:
Baro, QNH or altitude according to the setting
1)
in Setup.
The present altitude is stored when switching
2)
off in the QNH mode. On next switching on,
this altitude is used as a basis for the
QNH calculation.
18