DOM FAMILY Coast Rider Manuel D'instructions page 12

3. For the other side, pull out the center of the support bar slightly and insert the
support bar into the connector (Fig 6);
4. Adjust the support bar into place (Fig. 7 ).
6
5. Attach the holder to the handle bar connector. The cylinder on the handle bar
should be aligned with the hole in the bracket (Fig 8).
6. Firmly fasten the xing buckle to the left until completely ejected (Fig 9).
Try to shake and do not fall o to indicate that it is in place.
7. When disassembling the canopy, press the button and lift the xing buckle
toward the side to open (Fig 10).
8
8. Press the metal pin inward to adjust the height (Fig11 & 12).
11
7
Handle
connector
9
12
12
Buckle
10