Changing The Batteries - Dometic AP Remote Instructions De Montage Et De Service

AP Remote
5.4 Skysol Powered Roofblind and Skyscreen Powered
I
NOTE
In the figures the channels 1 and 2 are depicted as example for blind 1
and 2, respectively. The setup for channels 3 through 9 is done
accordingly.
Proceed as shown:
• Pairing or un-pairing the blind to AP Remote: fig. 8
Note: Ensure only the receiver for the blind being paired is connected to the
power supply and any other blind's receivers are disconnected.
• Changing the direction of blind: fig. 9
Note: Un-pair or disconnect from the power supply any other receivers on the
same channel. After changing the direction of the blind reconnect or re-pair
those receivers.
• Operating the blinds
– D2 blind type: fig. 0
– DM blind type: fig. a
– SO and S1 blind types: fig. b
– S2 blind type: fig. c
5.5

Changing the batteries

Observe the following notes on batteries:
• Do not mix battery types.
• Replace both batteries at he same time.
• Remove batteries when AP Remote will be left unused for long periods.
➤ Proceed as shown: fig. d
EN
Operation
5