Ingrediens Refill; Using Pulse Function; Crush Ice Cubes - Exquisit MU 3002 we Manuel D'instructions

1. Assemble the blender jug onto the
drive unit as described in "Compose
blender".
2. Remove the safety cover by turning it
counter-clockwise, until you can take
it off.
3. Fill the desired ingredients into the
blender jug.
4. Close the jug with the security cover.
5. Make sure that the speed control is set
to "0".
6. Connect the blender to a properly
installed socket.
7. To start the mixing process, turn the
speed control slowly up, until the
desired speed is reached.
8. To stop mixing for a while, turn the
speed control to level "0".
9. Wait for a complete stop of the blades
before you take the safety lid off.

13.3 Ingrediens refill

During the current mixing process, you
can add other ingredients.
1. Turn the lid insert counter-clockwise
until it stops and take it out.
2. Fill ingredients through the filler or
add small amounts of liquid.
3. Use the lid insert to refill other
ingredients.
Use the cover as a measuring cup. It is
suitable for measuring 30 ml, 40 ml and
50 ml of liquid.
1. Close the safety cover 2 with the lid
insert.
2. Turn the lid insert clockwise until it
clicks.

13.4 Using pulse function

The blender has a pulse function. It
means short operation at full power. By
using the pulse function is the maximum
speed is immediately available.
Use the pulse function if you want to mix
for a short time but intense. For example,
for foaming a liquid, or for crushing ice
(see "Crush ice cubes").
In order to enable this feature,
1. Turn the speed control 6 to the pulse
level "P" and hold it in this position for
as long as you want to mix. Use this
function only sporadically and never
exceed the maximum operating time.
2. Stop the mixing process by releasing
the speed control.

13.5 Crush ice cubes

1. Fill ice cubes into the blender jug 3.
Do not crush more than 10 to 12 ice
cubes per mixing process. Make sure
that the ice is not greater than 2.5 cm
edge length. With a small amount of
ice cubes, you get the best results.
2. Close the mixing bowl with the safety
cover 2 and the lid insert 1 (see
section "Compose blender").
3. Set the speed control 6 to level "0".
4. Connect the blender to a properly
installed socket.
5. Turn the speed control several times
for a short time to the pulse level "P"
and let it go again.
6. To end the crushing operation, set the
speed control to level "0".
7. Unplug the blender from the socket.
EN
Seite | 17