To Prevent Possible Damage To This Unit - HQ TORCH-EMC-02 Mode D'emploi

OPERATING MANUAL
Parts Instruction
POWER SOURCE
BATTERY OPERATION
1. Open the Battery Cover.
2. Put 4"AA" size (UM-3) batteries into the battery compartment, making sure that the batteries are installed
in the designated numerical order and that the proper polarities ("+"and"-") are maintained.

To prevent possible damage to this unit:

* Load new batteries with their polarities ("+" and"-") aligned correctly.
* Do not apply heat to batteries, or internal short circuit may occur.
* If this unit is not going to be used for a long period of time, remove all batteries and store them in a cool
and dry place.
* Remove spent batteries immediately and dispose them.
* Do not use old and new batteries together. Also never use an alkaline battery with a manganese battery.
To Charge the Built-in Ni-Mh Batteries
1. For better quality during charging, it's best to turn off the radio, flashlight and lantern.
2. Pull the cranking handle out.
3. Turn the cranking handle at a speed of 120 turns per minute or charge by DC IN, and the built-in batteries
will be full charged in approximately 1 hour.
ENGLISH
E-1073
Flashlight Radio
1. Volume Knob
2. FM/AM Band
3. Tuning
4. Speaker
5. LCD Display
6. Handle
7. Time Set Button
8. Hour Button
9. Min Button
10. Torch-Hi/Lo/Off/Lantern
11. FLASHLIGHT
12. LANTERN
13. Dynamo Handle
14. Battery Door
15. Carry Strap (With antenna)
16. DC IN jack
2
R 0.0