How To Operate - TrustFire SHP03 Mode D'emploi

HOW TO OPERATE

‹ On/Off
Under the unlocked state, press the neck switch
for 0.5 seconds to turn on/off.
‹ Gear Switch
When light is on, click the neck switch to change
gears in sequence of moon light mode low mode
medium mode high mode.
‹ Memory Gear
When the flashlight is in any gear, it will automatically
memorize the current working gear. Turn it off and turn on again,
it will still start working with the current memory gear.
(In strobe mode, no memory function)
‹ Strobe Mode
When light is off, long press 2 seconds to enter strobe mode
and the flashing frequency switches every 2 seconds.
Single click to return to the current mode.
Electronic anti-mispressing (Lock/Unlock)
‹ Lock: When the light is off, quickly double click
enter lock, after lock, it twice reminder low light
and slow flash to enter the lock mode;
‹ Unlock: When the light is under lock status,
quickly double-click to unlock and then
enter the constant bright mode;
‹ Magnetic Charging
Put the interface of magnetic charging cable gently close to
the charging position of flashlight, it will automatically attract
and start charging, the maximum current is 2A;
the red light of magnetic head shows charging,
the green light shows charging finished.
CHARGING DIAGRAM
magnetic rechargeable port
ANSI/
candle light
FSC
middle
mode
3lm 160lm
1000hours
16hours
/
75m
/ 1406cd
Intelligent temperature control, low voltage warning,
Additional
anti-reverse connection design, battery power indicator, magnetic charging,
Function
short circuit protection, tail magnetic attraction fixation function.
Note: The above parameters are only approximate values.
Tested done in 21700 5000mAh rechargeable lithium ion battery
laboratory environment, the value may change with the use
environment and battery.
battery indicator light
SPECIFICATIONS
Modes
extreme
high
bright
700lm 2500lm
3.9hours
168minutes
128m 360m
4096cd 32400cd
1m
IP68
strobe
2500lm
/
/
/