Guarantee; Troubleshooting - cartronic MHI-1100 Instructions De Service

MHI-1100.book Seite 15 Dienstag, 15. August 2006 1:59 13
MHI-1100
➤ Use the switch (see fig. 3, A, page 4) to select the desired heating level:
Switch
Heating capacity
position
0 The device is switched off.
1 The output is 550 W (measured at -20 ºC).
2 The maximum output of 1100 W is established
(measured at -20 ºC).
The maximum output at 0 °C is 1000 W.
7

Guarantee

Our general guarantee conditions apply. If the device is defective, please
contact your specialist dealer. For repair and guarantee processing, the fol-
lowing documents must be sent along with the device:
a copy of the receipt with purchasing date
a reason for the claim or description of the fault
8

Troubleshooting

Fault
The interior is cold. The
interior heater does not
work.
The interior is cold. The
interior heater started to
heat and then shut
down.
Interior heater blows
cold air.
The interior heater radi-
ates warmth, but the
fan does not work.
Possible cause
The switch is not set cor-
rectly.
The plug is not inserted
correctly.
The automatic overload
protection has switched
off the heater.
The heating element is
defective.
The fan motor is defec-
tive.
Suggested remedy
Observe the "Using the interior heater"
chapter on page 14.
Check the connections to the 230 V mains
supply.
Send or bring the interior heater back to
the dealer/supplier.
Send or bring the interior heater back to
the dealer/supplier.
Send or bring the interior heater back to
the dealer/supplier.
Guarantee
15