Please read and save these instructions
PACKAGE CONTENTS
Assembly and Installation
q If the solar panel is covered by a protective film. Remove it before using
the product. Move the ON/OFF switch to the ON position. Place the solar
light in a location where it can receive a full 8 hours of sunlight to allow
the rechargeable battery/batteries to reach maximum capacity.
1
Attaching and installing the light
q Attach the spike (D) to the post (C) by pressing them together and press
the post (C) into the bottom of the solar panel base (A).
C
ATTENTION
SPIKE
IS INSERTED
IN POST
2
Installation tips
q If the soil is of a loose, sandy or organic type, grasp the post with both
hands near the spike and firmly push into the ground.
q If the soil is hard, pour some water onto the ground to soften it.
q If the soil is stony, soften the ground with a rake or shovel and remove
large rocks. Dig a small hole, insert the fixture spike, replace the soil and
tap down.
q Never push the fixture into the ground by the fixture head.
WARNING: When planting the spike ensure that there are no underground utility
lines or pipes.
B
A
ATTENTION
LE PIQUET
EST INSÉRÉ
DANS LE POTEAU
D
Part
Description
A
A
Solar panel
B
String light
C
Post
C
D
Spike
D
3
Battery replacement
NOTE: This operation should be done in the morning on a sunny day. This will allow
the light to receive a full 8 hours of sunlight so that the rechargeable battery can reach
maximum capacity.
q Remove the four screws from the back side of the solar panel (A).
q Remove the cover.
q Remove the old battery and replace with one new AA NiMh
rechargeable battery of same or greater mAh.
(USE RECHARGEABLE BATTERIES ONLY).
NOTE : Clean the battery contacts and those of the device prior to battery installation.
q Be sure to insert the battery in the proper direction.
q Replace the battery cover.
q Replace the four screws.
Cover
Battery
A
Item #1001 090 125
Model #HDC28257WH75
Use and Care Guide
SOLAR STRING LIGHT
Quantity
1
1
1
1
Screws