Publicité
Les langues disponibles
Les langues disponibles
SINGLE BLOWER INSTALLATION
For hood model PWC362418 using blower
model 814419, 814420, or 814421.
For hood model PWC422418 using blower
model 814421.
MOUNTING PLATE
CENTER
PIECE
(4) 10-24 NUTS
(4) 10-24 NUTS
1. Mount blower to MOUNTING PLATE (provided with blower)
with (4) 10-24 NUTS (provided).
2. Remove CENTER PIECE of ADAPTER PLATE.
3. Mount blower / mounting plate assembly to ADAPTER PLATE
using (4) 10-24 NUTS (provided).
TOP OF HOOD
KEYHOLES
4. Fasten (4) 10-24 HEX NUTS (provided) to the (4) ADAPTER
PLATE STUDS leaving a 1/4" gap.
5. Lift blower into position inside hood. Engage all adapter plate
studs into KEYHOLES in top of hood. From TOP OF HOOD,
tighten all 4 hex nuts.
6. Plug blower POWER CORD into receptacle inside the hood.
Route wires away from blower's moving parts. Bundle wires
with wire tie (provided).
ADAPTER PLATE
(4) 10-24
HEX NUTS
(4) ADAPTER
PLATE STUDS
POWER
CORD
For hood model P I 363418 using blower model
SINGLE BLOWER INSTALLATION
For hood model P I 423418 using blower model
814419, 814420, or 814421.
814421.
MOUNTING PLATE
CENTER
PIECE
(4) 10-24 NUTS
(4) 10-24 NUTS
1. Mount blower to MOUNTING PLATE (provided with blower)
with (4) 10-24 NUTS (provided).
2. Remove CENTER PIECE of ADAPTER PLATE.
3. Mount blower / mounting plate assembly to ADAPTER PLATE
using (4) 10-24 NUTS (provided).
TOP OF HOOD
(2) THREADED
STUDS
(2) 10-24
HEX NUTS
4. Lift blower into position inside hood. Engage (2) TABS on
blower into (2) SLOTS in TOP OF HOOD. Secure blower to
(2) THREADED STUDS with (2) 10-24 HEX NUTS (provided).
5. Plug blower POWER CORD into receptacle inside the hood.
Route wires away from blower's moving parts. Bundle wires
with wire tie (provided).
MODEL • 814425
ADAPTER PLATE
(2) SLOTS
(2) TABS
POWER
CORD
Publicité
