System Commands - CrimeStopper SP-102 Mode D'emploi

SYSTEM COMMANDS

LOCK/ARM (Active Arming) - To arm the security system and lock the doors, press Button #1 (LOCK) on the remote. You will hear
a single chirp from the system and the parking lights will flash once. The system will arm, the doors will lock and the starter will be
disabled if these optional features have been installed. After the short 5-30 second delay to allow the vehicle and electronics to settle,
the system will be completely armed. The alarm status LED in the vehicle will begin flashing.
UNLOCK/DISARM (Active Disarm) - To disarm the security system and unlock the doors, press button 2 (UNLOCK) on the remote. You
will hear 2 chirps from the system and the parking lights will flash twice. The LED will stop flashing. The doors will unlock if the vehicle's
power locks are connected to the system.
Silent Arming - To silently arm the alarm, press Button #3 (SILENT) on the remote, the parking lights will flash one time and the system
will arm.
Silent Disarm - With the system already armed using SILENT ARM, press Button #3 (SILENT) and the system will disarm and flash the
parking lights twice.
Passive Arming - If programmed, Passive (automatic) Arming will occur 40 seconds after the ignition is turned OFF and the last door
has been closed. The LED will begin to flash rapidly while counting down. If a door, trunk, hood is reopened, the system will wait for the
door, trunk, and hood to close before arming. The unit will flash the parking lights once.
Active Re-Arming - The active re-arming feature allows the system to re-arm itself 40 seconds after being disarmed with the remote if
a door has not yet been opened. This is handy if the vehicle is accidentally disarmed (via the remote in your pocket) without you knowing
it. This feature can be turned ON or OFF in the programming.
Emergency Disarm/System Override - If you have lost the remote or it has stopped working for any reason and the vehicle is armed,
you will need to perform an Emergency Override to disarm the alarm. To do this, you will need to unlock the vehicle with the key in the
door. This will activate the alarm, the siren will sound and the parking lights will flash. Insert the key into the ignition and turn it to the
ON position. After the ignition is ON, press and hold the Override/Programming button for 4-5 seconds or until the alarm stops. This
will disarm the alarm.
4