Installation; Installation Tips And Warnings; Installation (Indoor/Outdoor) - FLIR LOREX LNZ32P12 12x Manuel D'instructions

4

Installation

4.1 Installation Tips and Warnings

Make sure to install the camera in a location that can support the camera weight. If mount-
ing the camera on a drywall surface, you must drill the mounting screws through a wooden
stud. See 4.2 Installation (Indoor/Outdoor), page 9 for full installation instructions.
• Camera is rated for outdoor use. It is recommended to install the camera in
a sheltered area, such as under the eaves on a roof.
• It is recommended to install the camera as high up as possible to get the
best possible image.
• Camera is capable of seeing in low light conditions (0.05 Lux), but it cannot
see in total darkness. It is recommended to install the camera where there
is some ambient light (e.g. street lighting or starlight, moonlight, etc.) or
leave some lighting on in the area where the camera is installed.
• Mount the camera where the lens is away from direct and intense sunlight.
• Plan your cable wiring so that it does not interfere with power lines or tele-
phone lines.
• Ensure you adhere to local building codes.
• Ensure that the camera wiring is not exposed or easily cut.
• Mount the camera in an area that is visible but out of reach.
This camera is suitable for wall and ceiling mounting.

4.2 Installation (Indoor/Outdoor)

To install the camera on a wall:
Make sure to disconnect power before installing the camera. Camera will begin moving im-
mediately when power is connected.
1. Mark holes for the mounting screws (x4) and cables through the wall
mount bracket. Drill where marked.
2. Pull the Ethernet cable from your NVR, PoE+ switch or router through the
hole in the mounting surface.
#LX400020; r.41770/42005; en-US
WARNING
NOTE
CAUTION
9