The Special Display Function - Phoenix Contact MCR-SL-D-SPA-UI Manuel D'utilisation

2. Functions
– Special display function,
see 4.2.2.1
– SiGnal allows selecting
the setpoint output in volts or mA.
– output.Low allows defin-
ing the lowest output value.
– output.High allows
defining the highest output value.
– StEP allows defining
the increment. During operation,
the setpoint output will increase by
this value when the right key is
pressed. The setpoint output will
decrease by this value when the
left key is pressed.
During operation, it is not possible to
define a value lower than the ou.Lo
value or higher than the ou.Hi value.
Note
If, during operation, the operator
switches to the programming mode
and alters the value of ou.Lo, ou.Hi,
di.Lo or di.Hi, the parameter StEP
will be reset to zero and the output
value will be reset to ou.Lo or di.Lo.
3. After setting the value of StEP,
press both keys simultaneously;
the following message is displayed:
4. Use the right key to select YES or
no
⇑
5. If YES is selected, press both
keys simultaneously to end the
programming. All parameters set
are saved.
⇑ ⇑
6. The device is ready for operation.
4.2.2.1 The
Function in MAn Operating
Mode
1. If YES was selected for
the display can show a value dif-
ferent from the value of the output
setpoint.

2.The SPecial disPlay function

A
– The function
SPecial.decimalPoint allows defi-
ning the number of decimal places
(only for the values appearing on
the display).
– display.Low allows
defining the minimum value to be
displayed. This value corresponds
to the value ou.Lo used for the
output setpoint.
SPecial disPlay
to
to
,
7