Publicité
Les langues disponibles
Les langues disponibles
Airboost Option for Ionstorm 3850 Bar
The Airboost Option Consists of:
•
6mm push-in air fitting
•
1mm holes on each side of all emitters
•
Acrylic sealant on all edges of extrusions and endcaps
Operation:
Air supply:
Must be clean and dry. Damp air could damage the high voltage components
inside the Bar. This is not covered by the product guarantee.
The Bar has been tested at 1Bar and 2 Bar air pressure. This is the normal
operating pressure range. Higher pressures than 2 Bar should not be used as
they could break the acrylic seal between the extrusions.
Please note: The 3850 Bar has no user serviceable parts. The warranty will be void if the
customer attempts to make repairs.
Instructions/Booklet/Ionstorm iss.8
Fraser Anti-Static Techniques Ltd
Tel: 44 (0) 1398-331114
email: sales@fraser-antistatic.co.uk www.fraser-antistatic.co.uk
Fax: 44 (0) 1398-331411
12
Publicité
