Air Quality Indicator - Braun Scan & Clean BFD104BE Mode D'emploi

Air quality indicator

The air quality indicator represents the air quality in the room detected by the sensors. The blue color
indicates that the air quality in the room has a lower level of contaminants, the red color indicates it has
a higher level of contaminants. When the unit is first turned on, the amber color indicates an increased
level of contaminants, and the red color indicates a higher level of contaminants, and the air quality
indicator will run between blue, amber and red for 30 seconds and stop at the respective color based on
the air quality detected by the sensors.
Particle sensor clean reminder
When the particle sensor indicator light (
sensor cleaning instructions on page 12).
The particle sensor should be cleaned every 3 months to optimize performance. After you have cleaned
the sensor, you will need to reset the indicator by pressing the reset button (
Cleaning the ECO filter
Ensure that the air purifier is unplugged from the wall outlet before cleaning the filter.
The ECO filter should be cleaned approximately once every 3 months.
1 2
Turn the power off and unplug Remove the ECO filter.
the air purifier.
If the filter still appears dirty, follow step 4-7. Otherwise proceed to "Drying" section.
DO NOT leave filter in water for more than 5 minutes.
4 5
Fill a sink with lukewarm water Gently swish the filter in the soap
and add a few drops of mild dish solution to clean.
soap.
8
) illuminates, you will need to clean the particle sensor (see
) twice in 1 second.
4
2
1
3
Rinse the filter with clean tap
water.
6
Soak the filter for 2-3 minutes.
DO NOT leave filter in water
for more than 5 minutes.
7
Rinse the filter with clean tap
water.
Note that the filter may still be discolored even after washing. This is normal staining that occurs
and will not affect performance.
Drying the ECO filter
1
Shake the filter to remove any
excess water.
4
When the ECO filter is
completely dry, place back into
2-3
the air purifier and return the rear
min
cover to its original place.
CAUTION:
• NEVER place a wet ECO filter in your air purifier.
• DO NOT place the ECO filter in a dishwasher or subject it to other extreme hot water conditions.
• DO NOT use any solvents, strong cleaning agents or flammable liquids to clean the ECO filter.
2 3
Place the filter on a towel. Allow the ECO filter to dry for a
few hours or overnight.
2
sec
5
Plug the unit into the power
outlet. When the unit is off, press
and hold the ECO filter reset
button for 2 seconds. The filter
indicator will flash twice and shut
off.
8
4
English
9