CHIEF MultiMig 721 Manuel D'instructions page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Postflow.
The adjustment may range from 0 to 25
Turn the knob 2 to select the parameter and confirm
the selection by pressing the knob.
The value is adjusted by turning the knob 2. To confirm
the selection simply hold down the knob 2 or the key
.
Press the key DEF to reset the factory set parameters.
Accessories USE OF THE MACHINE ACCESSORIES.
• Bluetooth controlled welding mask. (optional).
In order to use the mask, the kit must be already assem-
bled in the power source. You simply turn on the weld-
ing mask, activate the function on the power source
display, setting to ON and pair via Bluetooth the weld-
ing power source to the mask by selecting the "PAIR"
function. To test the function, simply press the "DARK"
button on the display ensuring that the mask glass be-
comes dark.
• Push-pull torch use instructions.
Adjustment of the Push-pull force can vary from -99
to +99.
This function adjusts the drive torque of the push-pull
motor in order to make the wire feed linear.
Turn the knob 2 to select the parameter and confirm
the selection by pressing the knob.
The value is adjusted by turning the knob 2. To confirm
the selection press knob 2 or the key
Press the key DEF to reset the factory set parameters.
This function will be displayed on the screen only
10
after this accessory is assembled inside the power
supply.
• Maximum inching.
The purpose is to stop the welding machine if the wire
flows for the preset length in cm after starting with no pas-
sage of current. Adjustment OFF - 50 cm.
Turn the knob 2 to select the parameter and confirm the
selection by pressing the knob.
To confirm the value, simply hold down the knob 2 or the
key
Press the key DEF to reset the factory set parameters.
Settings
• Date and Time Setting.
Turn the knob 2 to select parameter "Clock " and con-
firm the selection by holding down the knob.
Values are adjusted by turning the knob 2 and are con-
firmed by holding the knob down.
To confirm date and time press the key OK .
To exit the function press the key
• Factory setup resetting.
This function allows return to the factory preset values.
Three resetting modes are possible:
- All.
- Resets only stored "job" working programs.
.
- Excludes the "jobs": Resets all but saves "Job" work-
ing programs.
Turn the knob 2 to select the function and confirm the
.
MACHINE SETTINGS MENU.
.

Publicité

Table des Matières
loading

Produits Connexes pour CHIEF MultiMig 721

Table des Matières