monzana MZBC04 Mode D'emploi page 17

BATTERY:
Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a larger

diameter than NEGATIVE (NEG, N, -) post.
Attach at least a 24-inch-long 6-gauge (AWG) insulated battery cable to NEGATIVE

(NEG, N, -) battery post.
Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery.

Position yourself and free end of cable as far away from battery as possible - then

connect NEGATIVE (BLACK) charger clip to free end of cable.
Do not face battery when making final connection.

When disconnecting charger, always do so in reverse sequence of connecting

procedure and break the first connection while as far away from battery as practical.
A marine (boat) battery must be removed and charged on shore. To charge it on board

requires equipment specially designed for marine use.
AC POWER CORD CONNECTION INSTRUCTIONS
-
The plug must be plugged into an outlet that is properly installed in accordance with all

local codes and ordinances.
DANGER. Never alter AC cord or plug provided - if it will not fit outlet, have proper

outlet installed by a qualified electrician. Improper connection can result in a risk of an
electric shock. This battery charger is for use on a nominal 230 volt circuit.
LENGTH OF CHARGE
-
The following instruction will allow you to determine how long it will take to bring a

specific battery to full charge.
Test the battery for state of charger with a hydrometer or electronic percent-of-charge

tester.
Determine the size of the battery in Ampere-Hour or Reserve Capacity. If the ratings are

not printed on the battery, contact your local battery dealer for this information. These
are the only ratings that can be used to determine length to charging time.
Use the battery rating, the charge level of the battery, and amp setting to be used on

the charger in the formula provided below.
Amp Hour Rating of Battery × Percent of Charged Needed
Amp Setting Selected On Charger
If the battery is rated in Reverse Capacity, use the following formula to convert reverse
capacity to amp-hours.
Reverse Capacity
2
+ 15.5 = Amp-Hour Rating
17
= Hours to Charge
www.DEUBAXXL.de