Quick Start Guide - norse SK90 Mode D'emploi

SK90

Quick Start Guide

The following steps describe the quickest method to get your pressure washer up and
running. However, it is essential you fully read this manual to ensure you are familiar with
the general safety features, precautions and functions necessary to operate the product.
Failure to do so may result in injury and damage to your washer or personal items.
This high pressure washer
has built-in accessory
compartments. To assemble,
place handle into top of unit
and push forward to lock place.
Secure with included screw.
Connect one end of the high
pressure hose to the unit by
inserting it into front right side,
by pulling slightly on the hose it
will lock into the unit. The hose
is now securely attached.
Install the quick connector filter
and the quick hose connector.
Attach the quick connector filter
by screwing it into the water
inlet of the power washer.
Connect the other end of
the hose to the spray gun by
inserting next to the trigger. By
pulling slightly on the hose, it will
lock into the spray gun.
© NØRSE
English
Screw the quick hose connector
on to your garden hose and slide
onto the quick connector filter, it
will "click" into place.
On
Insert the extension lance into
the end of the spray gun by
pushing together and turning
clockwise at the same time.
Insert the fixed spray nozzle into
the end of the extension lance
by pressing the blue button on
the end of the extension lance,
then press the fixed spray nozzle
into the extension lance and turn
clockwise until it "clicks into
place.
Pump
Quick
connector
filter
Quick hose
connector
hose
3