Using The Control Panel; Operating Parameters; Setting The Temperature - Palazzetti EASY TOUCH Utilisation Et Fonctionnement

1.2 USING THE CONTROL PANEL

- The arrow buttons
- When selecting a given function, any submenus available can be scrolled using the
parameter simply use the
button confirms the setting.
- In general all values that are flashing can be modified using the
- The "annulla" button
active alarm or error codes.

1.3 OPERATING PARAMETERS

Stove operation is determined by the Power level and Temperature parameters set by the user.
1.3.1 setting the power level
The power level defines the amount of heat produced by the stove and consequently directly affects fuel
consumption.
To change the power level use the
a) Use the
b) Select submenu "1" and confirm by pressing
c) The power level value will flash; set the value using the
d) Press to confirm the settings.

1.3.2 Setting the temperature

Different temperature values can be set depending on the boiler's configuration:
a) Use the
b) The current value will flash; change it using the
c) Press to confirm the settings.
Water temperature (configurations 1 only): setting this value changes the desired hot water outlet temperature.
Room temperature (configuration 2 only): setting this value defines the desired room temperature, read
directly by a probe fitted on the boiler.
Storage temperature (configurations 3 and 4 only): identifies the minimum desired temperature inside the
storage tank.
are used to scroll between the different menus that are highlighted.
button and modify the values, again using the
goes back up one level in the menu; pressing and holding the button displays any
buttons to go to the power menu
buttons to scroll the submenu
buttons to go to the temperature menu
004773290 - 22/03/2021
buttons.
.
(buttons (1 minimum,....5 maximum)
and press ;
buttons
buttons; to set a
buttons. Pressing the
17