System Requirements - Danbit ACK-540 RF+ Manuel D'utilisation

2. Installation

2.1 System Requirements

This keyboard requires a PC with USB connection and one of the following operating systems:
For the installation of the keyboard under the mentioned above operating systems you need NO special
driver!
2.2 Installation of the USB receiver
In order to install your keyboard, please perform the following steps:
• Connect the included USB receiver (dongle receiver) to a free USB port
on your computer.
Advise:
Please ensure, that the USB receiver has a minimal distance
of 20 cm to metallic dividing walls, other computer cases,
monitors, ZIP drives, loudspeakers and switching power supplies.
• All above mentioned state-of-the-art operating systems which support the Plug & Play functionality of
Windows will recognize your keyboard automatically and load the required drivers. During the installation
phase, your operating system will inform you on your current status of installation through alternating pop-
up information windows on your task bar. Please be patient, until the system informs you finally about the
successful installation. The USB receiver is now ready for operation.
• Older operating systems not always support automatic recognition of USB devices. If you have attached
your USB receiver and exactly this error occurs on your system, you have the following alternatives to
solve the problem:
• Perform an update of your operating system and return to Step 2.2.
• In some cases the installation CD of your operating system is necessary according to the instructions on
your screen. In this circumstance please follow these instructions*.
• Check whether your BIOS system supports USB keyboards*. Some main board manufacturers offer
BIOS up-dates to download over the Internet.
• Ensure in your system settings, that the used USB connection is not deactivated in your operating
system*.
• Should your system updates still be unsuccessful, it is then recommendable to test the keyboard with
another PC with the same operating system to rule out a hardware damage of the USB receiver.
* Refer to the documentation of your PC for details.
Windows 98SE / ME / 2000 / XP / Vista / Windows7
- 10 -
Operation Manual ACK-540 RF+
E&OE