Aquaglide OCEAN POOL 4x4M Mode D'emploi page 16

16
ASSEMBLY
1) Locate a flat, dry area with access to electrical outlet or extension cord. The best
setup position will also make launching easy, so ideally the Ocean Pool should be
carefully carried into position at the water's edge.
NOTE: Dragging or sliding the Ocean Pool over ground either before or after inflation
can cause damage. It is best to attach Aquaglide items while they are deflated.
Once fully attached with Vario-Lock cinch straps, then inflate.
2) Once in the setup/ launch position, unfold the Ocean Pool completely and locate
the Main Valve. Remove the Main Valve cover and push valve plunger in. Twist the
valve stem 90 degrees to open or close the 1-Way valve feature.
3) Using a high output pump 10 psi (minimum), place the inflation hose with proper
adaptor into the Main Valve to inflate Ocean Pool. Inflate to 10 psi (0,69 bar). Check
for proper air pressure using a manometer. After inflation, replace Main valve cover.
Inflation times can vary by inflator, but the Ocean Pool should be firm and tight when
completely inflated.
DO NOT OVER-FILL. Excessively high pressure can cause damage to the product
and may void the warranty. Carefully monitor air pressure in the product especially
during hot weather. Repeat this step for the secondary valve on the Ocean Pool.
Inflate to 10 psi (0,69 bar). Check for proper air pressure using a manometer. After
inflation replace the main valve cover.
WARNING: Do not use an air compressor to inflate tube. Air compressors are
designed for high pressure inflation and can cause tube to burst if over-inflated.
WARNING: Do not use Ocean Pool without adequate air pressure - 10 psi (0,69 bar)
minimum.
4) You must use an Aquaglide accessory in order to board the product. Please follow
the Vario-Lock instructions in order to properly connect Aquaglide items together.
5) To launch the product, make sure to have at least 4 people evenly spaced around
the product to help carry it. NEVER DRAG THE PRODUCT! YOU MUST LIFT AND
SET THE PRODUCT ON THE WATER TO AVOID ANY ACCIDENTAL TEARING AND/
OR ABRASION.
How to connect your Aquaglide Products using the Vario-Lock cinch strap