This monitor will re-inflate automatically to approximately 220
mmHg if the system detects that your body needs more pressure
to measure your blood pressure.
Note:
1. This monitor automatically switches off approximately 1
minute after last key operation.
2. To interrupt the measurement, simply press the M or
START/STOP key. The cuff will deflate immediately after a key
is pressed.
3. During the measurement, do not talk or move your arm or
hand muscles.
12. Recalling Values from Memory
1. The Monitor has two Memory Zones (1 and 2). Each zone can
store up to 60 measurements.
2. To read memory values from a selected Memory Zone, use the
User-Switching Key to select a Memory Zone (1 or 2) from
which you want to recall values from. Then, press the M key,
and the values will be shown on the LCD display with an
assigned memory sequence number.
3. The monitor will display an average (AVG) of the previous
measurements first. Every new press of the M key calls for one
set of prior values stored. Latest memory will be recalled first.
The calculated average will be applied to a maximum of the
last 3 memories.
13. Clearing Values from Memory
1. Press the User-Switching key to select the
memory zone 1 or memory zone 2.
2. Continue to press and hold the M key for
approximately 5 seconds, then the data in the pre-
designated memory zone can be erased
automatically.
Note: the removal of even one of the batteries or the
disconnection of the supply unit from the power mains
causes the cancellation of the data contained in the 2
memory channels (1 and 2). We therefore suggest
transcribing the values in the "Blood Pressure Log (see
page 61 and 62) before replacing or removing the
batteries, or disconnecting the supply unit from the
power mains.
MON
D
MON
M
Press and hold
for 5 seconds.
SYS
mmHg
kPa
DIA
mmHg
MON
D
Pul.
min.
M
SYS
mmHg
kPa
DIA
mmHg
Pul.
min.
MON
D
M
SYS
mmHg
SYS
mmHg
kPa
kPa
DIA
mmHg
DIA
mmHg
Pul.
min.
MON
D
Pul.
min.
D
SYS
mmHg
kPa
DIA
mmHg
Pul.
MON
D
SYS
mmHg
kPa
DIA
mmHg
Pul.
min.
min.
16