Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2 . Installation instructions
The Cosiloft is supplied complete with pressure regulator (30 mbar) and gas hose. You only need to purchase a
gas bottle. These can be purchased at your local gas supplier. See pages 31 & 32 for a visual representation of
the mounting instructions.
1. Installing the Cosiloft
Carefully remove your Cosiloft from its packaging and select the location for your Cosiloft. The location must
meet the following conditions:
-
Make sure that the Cosiloft is placed on a paved (preferably stone) surface. The surface should be
completely flat and clean.
-
The Cosiloft should be placed at least two meters away from flammable materials and liquids.
-
After placing the frame on a stable surface, you can now place the table top on the frame. Then you can
place the burner into the recess in the table top.
Before the Cosiloft is ready to use you have to place an AAA battery for the piezo ignition. Please see '2.5
Replacing the battery for the piezo ignition.'
When the Cosiloft is installed properly, you can place the lava rocks and ceramic logs on the top. Start by
unpacking the small lava rocks and place these on the ground. Every product from Cosiloft is supplied with small
and large lava rocks. Take the small lava rocks without grit and place these gently on the model. Repeat the
process with the big lava rocks and make sure the fire ring is covered with lava rocks. Keep the space around the
ignition unit free of lava rocks.
After placing the lava rocks, unpack the ceramic logs. The Cosiloft 100 bar table is always supplied with four
pieces. Place the ceramic logs as a camp fire over the fire ring.
Make sure the fire ring is only minimally covered by the logs. If the logs block the fire ring, dangerous situations
may occur. The blockade of the fire ring will affect the air flow of the ring and the flames will be different. This
results in dangerous situations! It is recommended to place the ceramic logs as follows:
If you want to order more lava stones or ceramic logs, this is possible at your purchase address.
Pay Attention: When you are going to use the Cosiloft for the first time, make sure that the device is turned at
the highest setting for 15 minutes. In this way, the lava stones are heated through and this ensures that any
bumps or air bubbles will disappear from the lava rocks. During the first time the Cosiloft is turned on or when
the lava rocks have been wet (after some rain), keep at least two meters away from the burner and also ensure
that no flammable materials are placed around or on the table within this radius of two meters. Because the
air bubbles are burned from the lava stones, the stones can jump up during the first time / when lava rocks have
been wet and possibly come out of the burner.
12
Publicité
Table des Matières
