Filling The Tank - Umuzi Cleaning UZ-PC-ADP01 Manuel D'utilisation

Filling the tank

• Gently loosen the main body (C) from the tank (D) by turning it counterclockwise.
• Remove the tank (D) from the main body (C)
• Fill the tank with liquid soap or disinfecting gel.
• Do not overfill the tank (280 ml Max).
• Place the main body (C) back on the tank (D) by turning it clockwise.
Note! Only use fresh new soap and clean the tank properly before each re-fill.
Note! Do not fill the tank with exfoliant soaps.
Note! The device is suitable for alcohol disinfectant with an alcohol content of ≤ 75% (gel sanitizers) or
liquid soap. The device is not suitable for alcohol liquid (pure water liquid).
Powering the device ON/OFF
• After the batteries have been placed, press the power button (1) once. The LED indicator flashes once.
• There is no need to power off the device, as the sensor is in standby mode.
• In case you want to switch off the device, press the power button (1) until the LED indicator flashes red.
Note! When the battery level is low, the LED indicator on the power button (1) lights up red when holding
your hand under the motion sensor (B).
Setting the dispensing dose
• Press the power button (1) once. The LED indicator flashes once
Low: 1 - 1.5 ml.
• Press the power button (1) again. The LED indicator flashes twice
Medium: 2.5 - 3 ml.
EN-5