Cleaning & Maintenance - Alpina SF-5062 Mode D'emploi

ENGLISH
Place and Operation
1. Always place the humidifier on a firm, clean and flat level surface. Figure 6
2. Place the unit at least 2 meters away from TV, sound box and other home appliances; do not allow the
moisture outlet to face directly the wall and home appliances. Figure 7
3. Never place the humidifier near combustible materials such as curtain etc. Figure8
4. Do not place the unit near the stove and other heat sources and do not expose the humidifier under
direct sunshine. Figure 9
6
How to use function key:
Power knob: Plug in, the unit is on stand by position. Turn the power knob
clockwise then the green indicator light will turn on. Turning the knob will
adjust the quantity of mist from left to right becomes bigger and bigger until it
reach the maximum quantity of mist. It is suggested to choose the maximum
quantity of mist when air in the room is very dry.
Warning:
This appliance is equipped with a grounded, Type G, 3-pin power supply cord. This is a safety feature. Do
not attempt to defeat the safety purpose of this plug.
Troubleshooting:
Problem
1. Power light is off
2. Unusual Smell
3. Unusual Noise
Cleaning & Maintenance
1. Lift the Water Tank from the Base, remove the tank cap and drain any water from the Water Tank.
Rinse the Water Tank with lukewarm water after each use.
2. DO NOT immerse the Base in water. Gently wipe the reservoir with a soft, clean, wet cloth.
3. DO NOT use detergent, abrasive cleansers or brushes to clean the nebulizer that is not produced or not
under the supervision of the manufacturer.
4. DO NOT leave water in the Water Tank or reservoir when the unit is not in use as it could result in the
buildup of mineral deposits and bacteria that can inhibit the output efficiency of the humidifier. Please
note that if water remains in the Water Tank for more than a day, bacterial growth is possible.
5. Weekly Maintenance: Thoroughly clean the humidifier every week using a solution of bleach and water
(one teaspoon of bleach in one gallon of water). Fill the Water Tank partially with this solution, let it
remain in the water tank within twenty (20) minutes, shake it every few minutes. Drain and rinse with
clean water.
7
Please check the following item before having it repaired
Reason
a. Check if the unit is plugged in
b. The unit is new
a. The water is dirty or keep too long
a. It might be caused by lack of water
8
Solution
a. Plug in the unit and turn the
power knob
b. Open the water tank cap
and keep it in shady and
cool place for 12 hours.
Change the water
a.
a. Fill the water tank
9