Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Unpacking Your Freezer
1. Remove all packaging material. This includes the foam base and
all adhesive tape holding the freezer accessories inside and
outside.
2. Inspect and remove any remains of packing, tape or
printed materials before powering on the freezer.
Adjusting Your Freezer
Your freezer is designed for freestanding installation only.
•
It should not be recessed or built-in.
Place the freezer on a floor strong enough to support it fully loaded.
•
When moving the freezer, never tilt it more than a 45-degree angle.
•
This could damage the compressor and the sealed system.
If the freezer is tilted let it stand in an upright position for at least 24
•
hours prior to plugging. This is to allow the refrigerant to settle.
Proper Air Circulation
To assure your freezer works at the maximum efficiency it
•
was designed for, you should install it in a location where there is
proper air circulation, plumbing and electrical connections.
The following are recommended clearances around the freezer:
•
Sides...............4" (102mm)
Back...................4" (102mm)
Top....................Do not block
4
Installing Your Freezer
Publicité
Table des Matières
