KING Vento P 276 Manuel page 3

2) OPERATING MODE:
OPERATING MODE
1.
Connect the hose accessories:
Press the adaptors at both side of the hose end, then insert the hose into the hose
socket.
2.
Connect the metal tube to the curved end of hose.
3.
Connect the different nozzle tools/floor brush to the tube for different cleaning
purposes. The floor brush has two positions, soft/textile surfaces. The combi nozzle
is for narrow surfaces.
4.
Turn on the appliance:
Hold the plug and pull out the cord, then insert the plug into the power socket. Make
sure that the power supply corresponds to the required power mentioned on the
rating label. Press the on/off switch pedal to turn on the power. Adjust power to the
required level.
5.
Turn off the appliance:
After using, press the on/off switch pedal, the appliance is turned off.
Pull the plug out of the power socket, press the cord rewinding pedal, the power cord
will be drawn in.
6.To move the appliance from room to room, unplug and carry it by using the handle.
Never pull the appliance by its cord when moving.
3) MAINTENANCE:
1.
When the dust full indicator turns to red, it is time to clean the dust bag .To do that,
please follow the instructions:
(a)
Open the front cover by pressing the lock clip
(b)
Remove the dust bag .
(c)
Empty the dirts inside the dust bag .
(d)
Put back the dust bag .
(e)
Close the front cover .
NOTE:
1.The motor protection filter(as found under the
front cover) should be removed and rinsed twice
a year or whenever it is visible clogged. If the
filter is damaged, a new filter should be replaced.
For the HEPA filter, please use a soft bristled
brush for cleaning.