6
Operating Instructions
Checking for Leaks
W WARNING: Before using this outdoor fireplace, make sure you have
read, understand and are following all information provided in the
"Dangers and Warnings" section on page 2. Failure to follow those
instructions can cause death, serious injury or property damage.
Burner Connections
1.
Make sure the regulator hose and valve connections are securely fastened to the burner
and the tank.
2.
Visually check the connection between the burner/venturi tube and orifice.
3.
Make sure the burner/venturi tube fits over the
orifice.
W WARNING: Failure to inspect
this connection or follow these
instructions could cause a fire or an
explosion which can cause death,
serious bodily injury or damage to
property.
4.
Please refer to diagrams for proper installation
5.
If the burner/venturi tube does not rest
flush to the orifice as shown, please contact
1.800.762.1142 for assistance.
Tank/Gas Line Connection
1.
Make 2-3 oz. of leak detection solution by
mixing one part liquid dishwashing soap with
three parts water.
2.
Make sure control knob is in the " OFF"
position (Figure 6).
3.
Connect LP gas tank per "Installing LP Gas
Tank" section.
4.
Turn LP gas tank valve to "OPEN."
5.
Spoon several drops of solution, or use a
squirt bottle, at all "X" locations (Figure 5).
a. If any bubbles appear, turn LP gas tank
valve to "CLOSED," reconnect and re-test.
b. If you continue to see bubbles after
several attempts, turn LP gas tank valve to
"CLOSED" and disconnect LP gas tank, per
"Disconnect LP Gas Tank" section. Contact
1.800.762.1142 for assistance.
c. If no bubbles appear after one minute, turn
LP gas tank valve to "CLOSED," wipe away
solution and proceed.
Lighting Instructions
W CAUTION: Keep outdoor gas
appliance area clear and free from
combustible materials, gasoline and
other flammable vapors and liquids.
W CAUTION: Do NOT obstruct the flow
of combustion and ventilation air.
W CAUTION: Check and clean burner/
venturi tubes for insects and insect
nests. A clogged tube can lead to a
fire.
W CAUTION: Attempting to light the
burner with a cover on it may cause
an explosion.
1.
Make sure all labels, packaging and protective
films have been removed from the outdoor
fireplace.
2.
Make sure there are no obstructions of airflow to the gas unit. Spiders and insects can
nest within and clog the burner / venturi tube at the orifice.
3.
Connect LP gas tank per "Connect LP Gas Tank" instructions.
4.
The control knob must be in the "OFF " position (Figure 6).
5.
Wearing Heat reistant gloves, position the lit long match or lit long butane lighter near the
side of the burner. (Figure 7)
6.
Turn control knob counterclockwise to (HIGH) .
7.
Remove long match/long butane lighter.
8.
If ignition does not occur in 5 seconds, turn regulator/control knob to "OFF" position, wait
5 minutes and repeat lighting procedure.
9.
After lighting, observe the burner flame. Make sure all burner ports are lit and flame height
matches illustration (Figure 8).
W CAUTION: If burner flame goes out during operation, immediately turn
the gas "OFF" and let the gas clear for about 5 minutes before re-
lighting.
Turning Off
1.
Turn control knob to the "OFF " position (Figure 6).
Note: A "poof" sound is normal as the last of the LP gas is burned.
2.
Disconnect LP gas tank per "Disconnecting LP Gas Tank" section.
Cleaning and Care
W CAUTION:
1. All cleaning and maintenance should be done when outdoor
Figure 5
2. Do NOT clean any outdoor fireplace part in a self-cleaning oven.
3. Do NOT enlarge valve orifices or burner ports when cleaning the
Notices
1.
This outdoor fireplace should be thoroughly cleaned and inspected on a regular
basis.
2.
Abrasive cleaners will damage this product.
3.
Never use oven cleaner to clean any part of this outdoor fireplace.
Before Each Use:
Figure 6
1.
Keep the outdoor fireplace area clear and free from any combustible materials, gasoline,
and other flammable vapors and liquids.
2.
Do NOT obstruct the flow of the combustion of LP gas and the ventilation of air.
3.
Keep the ventilation opening(s) of the LP gas tank area free and clear from debris.
OFF
4.
Visually check the burner flames to make sure your outdoor fireplace is working properly
ARRÊT
(Figure 5).
5.
See sections below for proper cleaning instructions.
6.
Check all gas connections for leaks.
7.
Check components for any signs of damage or rust.
8.
Check for obstructions of airflow to the burner. Spiders, insects and webs can clog the
burner/venturi tube. A clogged burner/venturi tube can lead to a fire.
9.
If damage to any component is detected, do NOT operate until repairs are completed.
Cleaning Surfaces
Figure 7
1.
Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water.
2.
For stubborn stains, use a citrus-based cleaner and a nylon scrubbing brush.
3.
Rinse clean with water.
4.
Allow to air dry.
Before Storing
1.
Turn LP gas tank valve to "CLOSED."
2.
Turn control knob to the " OFF" position.
3.
Disconnect LP gas tank per "Disconnecting LP Gas Tank" section.
4.
Clean all surfaces.
5.
Lightly coat the burner with cooking oil to prevent excess rusting.
6.
Cover this outdoor fireplace with a durable vinyl cover.
Figure 8
7.
Store in a cool and dry location away from children and pets.
Product Registration
For faster warranty service, register your product immediately at BlueRhino.com/warranty or by
calling 1.800.762.1142.
Replacement Parts
Replacement parts can be found at parts.BlueRhino.com or by calling 1.800.762.1142.
LP Gas Outdoor Fire Bowl
Model No. GLT1343SP
fireplace is cool and with the fuel supply disconnected.
The extreme heat will damage the finish.
valves or burners.