Aux-In Operation; Remote Control - iDance DISCO CUBE BC-100L Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
USB player operation
1. Turn the unit on and switch to USB mode.
2. Plug the USB flashdrive into the USB PLAYER socket on the rear side of the unit.
3. USB and the song index will be shown on the LCD display.
4. Press Next / Previous to select to next or previous track.
5. During USB playback, press the PLAY/PAUSE button to pause USB play and press again to resume.

AUX-in operation

You can play other music sources (iPod, MP3 or other digital audio players) through the speakers of this unit by connecting the AUX IN JACK to your external
player's audio out jack or headphone jack
1. Plug one end of a 3.5mm audio input cable (not included) into the AUX IN input on the rear of the unit, and plug the other end of the cable into the audio
output on the external music player or other source.
Note: Make sure your external music player is turn ON.
2. Turn on the unit and switch to AUX-in mode
3. Start playing the device you plugged into AUX IN input. Their output is mixed with playback from BLUETOOTH or MIC IN.
4. Slowly adjust both the volume controls of the unit and the external device until you reach a comfortable listening level.
5. Press STANDBY button again to turn off the unit. Remember to shut down the external player power

Remote Control

4
3
2
5
6
8
11
9
12
15
1. [STANDBY] POWER Key
2. [SCAN] Scan Key
3. [MODE] Choose Signal Input
4. [MUTE] Mute Key
5. [FL-] Previous Folder
1
6. [FL+] Next Folder
7. [
] Press once to play the songs only in current folder in a loop; Press twice to play the songs in all folders
8. [VOL+] Increase music volume
9. [PLAY/PAUSE] Play / Pause Key
7
10. [CH+ /
] NEXT Song
11. [CH- /
] Previous Song
12. [VOL-] Decrease Music Volume
13. [0-9 Buttons] Choose song number directly
14. [REP] Repeat Song
15. [EQ] Different Sound Effects
10
Specification
Power Requirement:
AC/DC Adaptor: AC Input 100-240V ~50/60Hz
DC Output: DC 9V
Bluetooth: Bluetooth Specification version 2.1
13
Support profile A2DP
USB Player: Support USB flash drive up to 16GB. DC5V 200mA
Microphone: 600 Ohm Impedance w/6.3mm Dynamic microphone
Speaker: 4 Ohms. 10.2 cm. x1 4.1 cm. x1
14
EN4

Publicité

Table des Matières
loading

Table des Matières