Publicité
1. VOLUME
Controls the volume of the subwoofer. Adjust to get the best mix between your midrange speakers
and PA110-SC and PA112-SC. It is common for this control to be set between ½ and full when using
with a Kustom PA speaker.
2. IN
This ¼ inch jack is used to connect the PA110-SC and PA112-SC to a line level output such as the
subwoofer out on a Kustom PA speaker. It has a built in crossover to allow connection to full range
line level outputs.
NOTE: Do not connect the speaker outputs on a power amp to this jack.
3. OUT
This ¼ inch jack parallel's the signal on the IN jack. The purpose of this jack is to pass the signal
going to the IN jack to another Line level device such as a second powered PA or Subwoofer. NOTE:
This is not a power amp output. It will not drive an unpowered (passive) speaker.
4. POWER
This switch activates AC power to the powered PA.
5.AC Power Cord Receptacle
Insert the PA110-SC and PA112-SC's AC cord firmly into the AC receptacle. Be sure to use the
cable provided with your PA110-SC and PA112-SC. The power cord can be removed for storage or
replacement if damaged. Note: Replace the AC cord if its protective jacket is damaged or ground pin
is damaged or removed.
1. VOLUME
2. IN
3. OUT
4. POWER
5. AC POWER CORD RECEPTACLE
Publicité
