Inserting Batteries; Operation; Cutting Hairs Longer Than 10 Mm - Balance KH5530 Mode D'emploi

Inserting the batteries
The compartment for the batteries is located on the bot-
tom of the device.
➩ Hold the Lady Shaver firmly in the centre of the hou-
sing with one hand.
➩ Turn the battery cover
➩ Insert two AA 1.5 V batteries (polarity labels in the
battery compartment) into the battery compartment.
➩ Place the battery cap back on the Lady Shaver from
below until it snaps into place.

Operation

We recommend taking a warm bath/shower before using
the Lady Shaver. This preparation makes the subse-
quent shaving easier.
➩ Apply shaving foam to the skin before shaving, if
necessary.
24
then pull it down and off.

Cutting hairs longer than 10 mm

Use the long hair cutter before shaving.
➩ Remove the protective cap
➩ Press the ON switch
➩ Press the button in the middle of the long hair cutter
ON/OFF switch and hold it pressed.
➩ Push the long hair cutter ON/OFF switch upward until
it stops.
➩ Shorten the hairs with the long hair cutter to less
than 10 mm.
➩ Hold the long hair cutter on the Lady Shaver parallel
to the skin.
➩ Run it against the grain of the hairs.
➩ When finished, press the OFF switch
.
.
.