Safety Feature - INVENTOR G4INV-20DTB Manuel D'emploi

1.5 TURN OFF
Keep pressing " " in any status to turn off the unit, until the power indicator light is off.
NOTE: Temperature Control and Setting Timer can be activated both from the central unit or
from the remote controller.
1.6 CHILDREN SAFETY LOCK FUNCTION
Under the working mode, press both " " and " " at the same time for 3 seconds to lock the
system. Then a square " " is displayed. 3 seconds later it resumes to inspection temperature
display status. If there is a key pressed, the symbol " " will show for 3 seconds without buzzer
hint, and then it resumes to inspection temperature display status again. Methods to unlock:
1) Turn off the unit by the side button. 2) The timing previously set is completed 3) Press both
" " and " "for 3 seconds.
NOTE: Only from the main unit (not the remote controller)
1.7 POWER SELECTION
Press button " " to select the output power. The heater will work with the full Rated output
when "HI" is displayed. Press button " " again to switch to "LO" heating mode.
1.8 ACTIVATION OF THE ION GENERATOR
Press the " "on, the ION indicator will be on, then the ION feature will start operating, providing
cleaner air in the room. Press once again " " to deactivate.
1.9 LOCKING THE CONTROL PANEL FUNCTIONS
1.9.1 ELECTRONIC LOCKING - Refer to section 1.6

2. Safety feature

The unit is equipped with a high limit switch; the heater will automatically shut down if it is in an
over-heating condition.
It will automatically restart when it cools down.
The heater has a safety switch which will deactivate the appliance in the event it is tipped over
or tilted.
3. Cleaning behind the heater
Cleaning behind the unit is a very easy process.
After cleaning, the heater must be placed in the normal position.
The heater requires regular cleaning to ensure trouble-free operation:
Unplug the heater from the mains supply before cleaning.
Ensure that the heater has cooled down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the heater, so as to remove dust and dirt. Use
a vacuum, cleaner to remove dust and fluff around the grilles.
Ensure the heater is dry before plugging back into the mains supply.
6